Natural gas is not only playing an increasing important role in energy and chemicals supplies in 21st century but is also the second most important component of the greenhouse gases. Clean and direct conversion of methane to C 2 hydrocarbons (ethane, ethene and acetylene) through AC and DC plasma catalysis enhanced by electric field was studied at low temperature ranging from 50?℃ to 100?℃, atmospheric pressure and low power conditions. The influence of form of the electrode, distance between the electrodes, voltage, diameter of reactor, flow of inlet methane, N 2/CH 4(mole) and 20 catalysts were tested under low temperature plasma. The results indicated that best form of the electrode was plate; the better distance between the electrode was 5mm; the appropriate voltage was 38V(AC);the apparent diameter of reactor was 17mm, the likely flow range flux of inlet methane was 60—80?ml·min -1 , the suitable ratio of N 2/CH 4 (mole) was 0.5—1.0.The yield of C 2 hydrocarbons was the highest on V 2O 5,ZnO(5%)/ZSM-5-38 catalyst, the yield of ethene was the highest on La 0.8 Sr 0.2 CrO 3,ZnO catalyst. The results are better than those obtained through conventional reaction of oxidation coupling of methane.
The experiments are carried out in the system of continuous flow reactors with dielectric-barrier discharge (DBD) for studies on the conversion of natural gas to C2 hydrocarbons through plasma catalysis under the atmosphere pressure and room temperature. The influence of discharge frequency, structure of electrode, discharge voltage, number of electrode, ratio of H2/CH4, flow rate and catalyst on conversion of methane and selectivity of C2 hydrocarbons are investigated. At the same time, the reaction process is investigated. Higher conversion of methane and selectivity of C2 hydrocarbons are achieved and deposited carbons are eliminated by proper choice of parameters. The appropriate operation parameters in dielectric-barrier discharge plasma field are that the supply voltage is 20-40 kV (8.4-40 W), the frequency of power supply is 20 kHz, the structure of (b) electrode is suitable, and the flow of methane is 20-60 ml · min-1. The conversion of methane can reach 45%, the selectivity of C2 hydrocarbons is 76%, and the total selectivity of C2 hydrocarbons and C3 hydrocarbons is nearly 100%. The conversion of methane increases with the increase of voltage and decreases with the flow of methane increase; the selectivity of C2 hydrocarbons decreases with the increase of voltage and increases with the flow of methane increase. The selectivity of C2 hydrocarbons is improved with catalyst for conversion of natural gas to C2 hydrocarbons in plasma field. Methane molecule collision with radicals is mainly responsible for product formation.
